Faure FEL6640FBA Uživatelský manuál Strana 11

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 20
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 10
Problem Possible cause Remedy
Automatic Heat Up function does
not operate.
The zone is hot. Let the zone become sufficiently
cool.
The highest heat setting is set. The highest heat setting has the
same power as the function.
The heat setting changes between
two levels.
Power management function oper-
ates.
Refer to "Daily use" chapter.
The sensor fields become hot. The cookware is too large or you
put it too near to the controls.
Put large cookware on the rear
zones if possible.
comes on.
Automatic Switch Off operates. Deactivate the hob and activate it
again.
comes on.
The Child Safety Device or the Lock
function operates.
Refer to "Daily use" chapter.
comes on.
There is no cookware on the zone. Put cookware on the zone.
The cookware is incorrect. Use the correct cookware.
Refer to “Hints and tips” chapter.
The diameter of the bottom of the
cookware is too small for the zone.
Use cookware with correct dimen-
sions.
Refer to “Technical information”
chapter.
and a number come on.
There is an error in the hob. Disconnect the hob from the electri-
cal supply for some time. Discon-
nect the fuse from the electrical sys-
tem of the house. Connect it again.
If comes on again, speak to an
Authorised Service Centre.
comes on.
There is an error in the hob because
a cookware boils dry. Automatic
Switch Off and the overheating pro-
tection for the zones operate.
Deactivate the hob. Remove the hot
cookware. After approximately 30
seconds, activate the zone again. If
the cookware was the problem, the
error message goes out. Residual
heat indicator can stay on. Let the
cookware become sufficiently cool.
Check if your cookware is compati-
ble with the hob.
Refer to “Hints and tips” chapter.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.
Make sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not be
free of charge, also during the warranty period. The
instructions about the Service Centre and conditions of
guarantee are in the guarantee booklet.
11
Zobrazit stránku 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Komentáře k této Příručce

Žádné komentáře